-
The only material allowed for rear end components including
yokes, hubs, drive plates and bearing supports is Steel
unless specifically listed below.
-
Housing
-
OEM rear ends must be stock steel
(we reserve the right to refuse use of any rear end
component with out reason)
- Distance from
center of rear end housing to the rear hubs left and
right must be within one inch in length.
- Center Section (Carrier)
- OEM Ring and pinions
- Any readily
off the shelf available gears allowed
- No custom
ground or lightened gears
- C-clip
eliminators are optional
- Welded spider
gears or spool may be used if the original pin and
carrier are maintained.
- No ratchet,
lockers, limited slip, torque bias, or aluminum
center sections permitted.
- Axels
- Full floating
rear axle permitted
- Heavy duty
aftermarket axles allowed
- Steel only
- May not be
gun drilled
- Gear Ratios
(Subject to change as needed)
- Gear ratios and or Chip rule will be announced track
to track.
- Tracks 3/8
mile or smaller the final drive cannot
exceed 6.25
- Tracks
greater than 3/8mile and less then a mile final drive
cannot exceed 5.25
|