- Bell Housing:
- 360-degree magnetic steel housing mandatory.
- No open bottom housings.
- 2" hole required for inspection of flywheel and clutch.
- Hole must be positioned on bottom.
- Clutch:
- Stock replacement magnetic steel clutch permitted
- 10" inch minimum.
- Clutch cover and pressure plate must be completely STEEL.
- No trick or multi disc clutches permitted.
- Hydraulic clutch controls permitted.
- Complete clutch & disc minimum weight 17 lbs.
- Flywheel: (All)
- Steel (magnetic steel) flywheel only.
- Minimum weight 16 lbs
- Transmission:
- Standard transmission must be stock manufactured through
Ford, GM or Dodge.
- Only three or four speed types may be used.
- All gears forward and reverse must be in working order.
- No internal modifications or lightning of parts permitted
must remain as original produced by OEM.
- After-market shifters permitted,
- Multi-Lever type shifter assemblies allowed
- Must not have any of the rods exposed to driver,
- sheet metal (22 gauge) must cover area.
- Stock manufactured automatics permitted
- Must have working stock torque converter
- No 2-speeds
- Drive Shaft
- Stock type Steel drive shaft only
- Must be painted white
- Minimum diameter 2 inches
- Two 360 degree drive shaft loops
mandatory
- 2 inches by 3/16ths flat bar
steel
or 1 inch round .095 steel tube
- Positioned near each u-joint.
|